How To Clean A Brother Sewing Machine Sq9000

How practise I clean the machine? (Cleaning the race)

Sewing performance will suffer if grit collects in the bobbin case; therefore, it should be cleaned periodically.

Make sure you lot unplug the machine earlier y'all clean it.
Otherwise, you may get an electric stupor or exist injured.

Plough off the machine, and then unplug the power cord from the power supply jack on the right side of the automobile.
Remove the needle.
Refer to How do I change the needle?
Remove the presser foot and presser foot holder.

Refer to How practice I remove or attach the presser foot? and How practise I remove the presser foot holder?

Slide the needle plate cover release toward y'all to remove the needle plate comprehend.

(1) Needle plate cover
(2) Needle plate cover release

Remove the bobbin instance.

(1) Bobbin case

* Grasp the bobbin case, and then pull it out.

Use the cleaning brush or a vacuum cleaner to remove any grit from the race and its surrounding area.

(1) Cleaning castor
(two) Race

Do non put oil on the bobbin case.

Insert the bobbin case so that the

mark on the bobbin instance aligns with the

marking on the race.

(1) marker

(2) mark

(3) Bobbin instance

* Marshal the triangle-mark

and

marks.

Make sure that the indicated points are aligned before installing the bobbin case.

Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may suspension or sewing performance may suffer.
For a new bobbin instance (part code: XE7560-001), contact your nearest authorized service eye.
Make sure that you fit the bobbin case properly, otherwise the needle may break.

Equally shown, insert the tab on the needle plate cover into the hole in the needle plate, and so correctly position of the needle plate cover.

(1) Needle plate cover
(2) Tab

(3) Hole

Check that the needle plate cover is affluent with the top surface of the car.

From the forepart, slide the needle plate cover back into position.

(i) Needle plate embrace

If the needle plate encompass is non flush with the surface of the machine as shown below, remove the needle plate cover (stride iv), and then install it again (steps 8 and nine).
Sewing while the needle plate cover is not flush with the surface of the machine may cause the needle plate comprehend to come off of the auto, resulting in injuries if your fingers touch the race.

Install the presser foot holder and presser pes.
Install the needle.

Related Models

CE1008, CE1100PRW, CE1125PRW, CE4400, CE-5500/CE-5500PRW, CE7070PRW, CE8080/CE8080PRW, CE8100, CP-6500, CP-7500, CS5055PRW, CS7130, CS7205, CS8800PRW, DZ2400, DZ2750, DZ3000, DZ3400, HC1850, HS-2500, PS300T, SB1000T, SC3000, SC6600, SC707, SC9500, SM8270, SQ9185, SQ9285, SQ9310, XR1300, XR1355, XR3140, XR3240, XR3340, XR4040, XR6060, XR9550/XR9550PRW, XS2070, XS2080, XS2100, XS3109